This is an old revision of the document!
This page only deals with the net80211 version of the madwifi-ng driver. For the mac80211 ath5k version see the mac80211 page. To understand the differences, see mac80211 versus ieee80211 stacks write-up.
If you have a new kernel that supports mac80211 and includes the new ath5k driver then you MUST blacklist it otherwise the net80211 version of the module below will not work. See blacklisting mac80211 driver version below.
ifconfig ath0 down ifconfig wifi0 down svn -r 3745 checkout http://svn.madwifi.org/madwifi/trunk/ madwifi-ng wget http://patches.aircrack-ng.org/madwifi-ng-r3745.patch cd madwifi-ng patch -Np1 -i ../madwifi-ng-r3745.patch ./scripts/madwifi-unload make make install depmod -ae modprobe ath_pci
Important: The above example uses revision 3745 of the madwifi-ng drivers. You can use the latest SVN version if you wish. Just be aware that in some versions injection rates are low or zero. R3745 is known to work well.
Support for Atheros chipID 0x0024 (rev 01) 802.11b/g/n cards (AR5008).
The new cards are now (experimentally) supported in trunk. The above code will cause them to work!
NOTE: 11n rates are not supported yet.
These are relevant links on the madwifi-ng.org site:
The following links are tarballs already containing everything needed:
The new official HAL (0.10.5.6) supports AR5007EG (and AR5006EG) on 32 and 64 bit systems. Use the instructions above but checkout http://svn.madwifi.org/madwifi/branches/madwifi-hal-0.10.5.6/ instead of http://svn.madwifi.org/madwifi/trunk/.
If you have the file ath5k.ko in the /lib/modules directory tree then you have two options to blacklist it. Failure to do this will mean that the ieee80211 madwifi-ng module described on this page will fail to work properly. Here are the options:
/lib/modules/$(uname -r)/kernel/drivers/net/wireless/ath5k/ath5k.ko to a safe place. Some parts of the path may be different on your distribution/system. Use “locate ath5k.ko” or “find /lib/modules -name *ath5k*” to find the full path. After moving it, do “depmod -ae”.
In both cases, reboot your system afterwards.
If you change the rate while capturing packets, airodump-ng will stall. There are two possible workarounds:
If you system contains a mini-PCI wireless card, there are some known issues and solutions. See the Madwifi-ng Mini-PCI page for a description of the known problems and solutions.