This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
cisco_pspf_bypass [2010/08/11 17:57] lmeiners |
cisco_pspf_bypass [2010/08/29 19:42] (current) mister_x Fixed channel/frequency graph link |
||
---|---|---|---|
Line 98: | Line 98: | ||
In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: http://www.rflinx.com/help/calculations/# | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
==== Step 2 - Start airodump-ng to capture the IVs ==== | ==== Step 2 - Start airodump-ng to capture the IVs ==== |