User Tools

Site Tools


broadcast_key_rotation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
broadcast_key_rotation [2010/08/11 17:55]
lmeiners
broadcast_key_rotation [2010/08/29 19:42] (current)
mister_x Fixed channel/frequency graph link
Line 99: Line 99:
 In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. ​ In the response above, you can see that mon0 is in monitor mode, on the 2.447GHz frequency which is channel 8 and the Access Point shows the MAC address of your wireless card. Please note that only the madwifi-ng drivers show the MAC address of your wireless card, the other drivers do not do this. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. ​
  
-To match the frequency to the channel, check out: http://www.rflinx.com/help/calculations/#​2.4ghz_wifi_channels then select the “Wifi ​Channel ​Selection and Channel Overlap” tab. This will give you the frequency for each channel.+To match the frequency to the channel, check out: http://www.cisco.com/en/US/​docs/​wireless/​technology/​channel/​deployment/​guide/Channel.html#​wp134132 ​. This will give you the frequency for each channel.
  
 ==== Step 2 - Use aireplay-ng to do a fake authentication with the access point ==== ==== Step 2 - Use aireplay-ng to do a fake authentication with the access point ====
broadcast_key_rotation.txt · Last modified: 2010/08/29 19:42 by mister_x