shared_key
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
shared_key [2008/05/09 23:44] – Better double-dash workaround. netrolller3d | shared_key [2010/08/29 19:48] – Fixed channel/frequency graph link mister_x | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Tutorial: How to do shared key fake authentication ? ====== | ====== Tutorial: How to do shared key fake authentication ? ====== | ||
- | Version: 1.08 May 9, 2008\\ | + | Version: 1.08 November 7, 2008\\ |
By: darkAudax | By: darkAudax | ||
File linked to this tutorial: [[http:// | File linked to this tutorial: [[http:// | ||
- | |||
- | |||
===== Introduction ===== | ===== Introduction ===== | ||
Line 109: | Line 107: | ||
In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | In the response above, you can see that ath0 is in monitor mode, on the 2.452GHz frequency which is channel 9 and the Access Point shows the MAC address of your wireless card. Only the madwifi-ng drivers show the MAC address of the card in the AP field, other drivers do no. So everything is good. It is important to confirm all this information prior to proceeding, otherwise the following steps will not work properly. | ||
- | To match the frequency to the channel, check out: | + | To match the frequency to the channel, check out: http://www.cisco.com/en/US/ |
- | http://www.rflinx.com/help/calculations/# | + | |
=== Troubleshooting Tips === | === Troubleshooting Tips === | ||
Line 141: | Line 138: | ||
00: | 00: | ||
- | Once "PSK" appears on the airodump-ng screen, do file listing and it will look something like: | + | Once "SKA" appears on the airodump-ng screen |
| | ||
Line 163: | Line 160: | ||
Where: | Where: | ||
* -0 means deauthentication | * -0 means deauthentication | ||
- | * 1 is the number of deauths to send (you can send muliple | + | * 1 is the number of deauths to send (you can send multiple |
* -a 00: | * -a 00: | ||
* -c 00: | * -c 00: |
shared_key.txt · Last modified: 2018/03/11 20:19 by mister_x