i_am_injecting_but_the_ivs_don_t_increase
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
i_am_injecting_but_the_ivs_don_t_increase [2008/05/09 23:40] – netrolller3d | i_am_injecting_but_the_ivs_don_t_increase [2009/08/14 19:08] – use dokuwiki internal links mister_x | ||
---|---|---|---|
Line 64: | Line 64: | ||
11: | 11: | ||
+ | | ||
+ | | ||
Notice that the access point (00: | Notice that the access point (00: | ||
Line 112: | Line 114: | ||
==== ARP Request Replay ==== | ==== ARP Request Replay ==== | ||
- | Use the standard [[http:// | + | Use the standard [[arp-request_reinjection|ARP request replay]] technique. |
This assumes that you have a wired or wireless client active. | This assumes that you have a wired or wireless client active. | ||
Line 118: | Line 120: | ||
==== Replay Previous ARP ==== | ==== Replay Previous ARP ==== | ||
- | You can replay an ARP which was previously captured. | + | You can replay an ARP which was previously captured. |
==== Use "-p 0841" Technique ==== | ==== Use "-p 0841" Technique ==== | ||
- | You can replay any data packet captured in real time. See this [[http:// | + | You can replay any data packet captured in real time. See this [[interactive_packet_replay# |
This assumes that there is at least one data packet broadcast by the AP or a wireless client. | This assumes that there is at least one data packet broadcast by the AP or a wireless client. | ||
Line 178: | Line 180: | ||
Although you can't see it, the above command started generating the IVs. As usual, run [[airodump-ng]] and [[aircrack-ng]]. | Although you can't see it, the above command started generating the IVs. As usual, run [[airodump-ng]] and [[aircrack-ng]]. | ||
+ | |||
Line 186: | Line 189: | ||
* With some drivers, the wireless card MAC address must be the same as MAC address you are injecting. So if fake authentication is still not working then try changing the card MAC to the same one you are trying to authenticate with. A typical package to do this is macchanger. | * With some drivers, the wireless card MAC address must be the same as MAC address you are injecting. So if fake authentication is still not working then try changing the card MAC to the same one you are trying to authenticate with. A typical package to do this is macchanger. | ||
- | * Some access points are configured to only allow selected MAC access to associate and connect. | + | * Some access points are configured to only allow selected MAC access to associate and connect. |
To determine if MAC access control is in place, enter the following command: | To determine if MAC access control is in place, enter the following command: |
i_am_injecting_but_the_ivs_don_t_increase.txt · Last modified: 2018/03/11 20:14 by mister_x